Frameless Installation Instructions
                                                                                                                                                                                                   
   Frameless Shower Enclosures   Glass Handrail Systems   Frameless Storefront Glass   Handicap Mirrors Convex, etc. 
                                                                                                                                                                                                   
   Venetian Mirrors   Frameless Installation Instructions   Frameless Shower Door Hardware   
                                                                                                                                                                                                  
        Mirrored wardrobe doors   Custom Oval & Round Mirrors  Our Customers' Comments   Company's Policies     
                                                                                                                                                                                                   
   HOME   About Us    E-MAIL     Tel: 310-276-1111      Tel:800-998-7479        Fax: 424-208-3842                                                                                                                                                                                                     

   Additional Options
  IF YOU SELECT TO PAY FOR A PRODUCT THROUGH PAYPAL SECURED ELECTRONIC INVOICING SYSTEM, PLEASE INFORM US, SO THE ARRANGEMENT WILL BE PROVIDED. AND THE ELECTRONIC INVOICE WILL BE SENT TO YOU DIRECT FROM PAYPAL.

INSTALLATIONS WITHIN 35 MILES RADIUSES FROM LOS ANGELES

Frameless Glass Installation Instruction # 103
At the time of installation enlarge the image by clicking on it and print it.
TO PRINT INSTRUCTIONS TOGETHER WITH THE GRAPHICS, PLEASE SELECT THE PAGE AND THEN PRINT.
“A"
Cut the channels according to the measurements, drill 2-3 holes and counter-sink them.. Drill few more holes so when you apply silicon, the air 
would not be trapped. Use flat head screws.		 wpe1.gif (18449 bytes) "B"
Apply a little clear silicon inside the first panel channels.
Insert the first panel in the channels while the silicon in the channel is not dried up yet.

 
“C” 
Apply a little silicon inside the channel where the second panel sits. Insert the second panel as it is shown. 

 

 “D”
  Secure the first and second panel by duct tapes and apply silicon at the 
joints from inside. Do not use silicon where the glasses touch at the miter locations.
Apply little clear silicon where the channels touch the tiles. Remove the duct tapes
the next day. Cut the door stopper ½” shorter and insert it to the edge of the panel.

 
Installation instruction
# 101 hinges
Set the glass door long-way on its front edge on a carpet.
While someone holding the door, insert the hinges on their location one by one.
Drive screws A and B firmly. DO NOT USE POWER TOOLS.
After you have secured the hinges on the door,
set two pieces of board, 3/8 of inch thick on
the curve where the door should be installed.

Set the door on the two boards. Alien it with the
right panel where the door stopper is. Make it 
sure that the door is in a perfect up-right position.		 wpe1.gif (16172 bytes) With a thin point marker, mark the location of
the screws on the wall. Now take the door down
and drill the holes. Insert plastic anchors. Now set
the door back on its original position on the
two boards. And secure it by driving the screws tide HOWEVER, IT WOULD BE A GOOD IDEA BEFORE SETTING THE DOOR UP, TO DRIVE THE SCREWS FIRST TO SEE WHETHER YOU CAN DRIVE THEM
WITHOUT TOO MUCH EFFORT.
(No power tools should be used.)
End E-MAIL  FAX 480-275-3133